Filter
Top Products
System Error Codes
2-19
HP DesignJet 5000 Series Printers Service Manual
System Error: 0B000D
Problem
Description:
24 V source test failure.
Corrective Action: Replace the Main PCA ⇒ Page 8-79.
System Error: 0B000E
Problem
Description:
At power-up, the Printer thinks it is smaller than 42 inches.
Corrective Action: Try the following:
n Check that there are no obstacles in the Scan-Axis which stops
the Carriage from reaching the end-stops on both sides.
n Check that the Carriage moves freely from side to side.
n Check that the IDS Crane is installed correctly on top of the
Carriage and that the Carriage Cover is clipped on correctly.
System Error: 0C0030
Problem
Description:
Drop Detector Failure.
Corrective Action: Try the following:
n Check that the Drop Detector Cable is NOT broken or damaged.
n Check that the Drop Detector cable is correctly connected to the
Service Station Cable.
n Remove the Drop Detector and make sure that there are no
obstacles inside which are blocking the sensor.
n Replace the Drop Detector Assembly ⇒ Page 8-70.
n If the System Error Code continues, replace the Main PCA ⇒
Page 8-79.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.