Filter
Top Products
Removal and Installation
8-65
HP DesignJet 5000 Series Printers Service Manual
Air Pressurization System (APS)
Removal
WARNING Switch off the Printer and remove the Power Cord.
1. Remove the Left Hand Cover - Refer
to Page 8-6.
2. Remove the Left Rear Cover - Refer
to Page 8-15.
3. Remove the Back Extension Cover
(Only for the 60" Model) - Refer to
Page 8-17.
4. Remove the ISS - Refer to Page 8-62.
5. Remove the cables and tube from the
slot on the ISS.
n For the 42" Model, open the Cable
Clip under the ISS holding the APS
Cables to the ISS.
NOTE When removing the APS
from the ISS, take care with
the tube and cables attached
to the ISS.
6. Push the retaining clips on the left side
of the APS to release it from the ISS.