Filter
Top Products
304
Communication
command
B
mode
2
• Page Writing of User Parameter
Reception data
21h
axis
page No.
parameter L
(value of No. 0 ) H
parameter value L
(value of No. 1 ) H
–
parameter value L
(value of No. 0th ) H
checksum
B2
Error code
Transmission data
• Designate 0 to 7 to page No. and write 16 parameters from each specified page.
• Set up o to parameters not in use without fail, or data error will occur. Data error will also occurs when data exceeding
the setup range is transmitted.
• No. error will be returned when other No. than 0 to 7 is entered to page No.
bit7
0 : Normal
1 : Error
6543210
2
axis
page No.
Error code
checksum
B2
Data Error Command error No.ErrorRS485 error