Filter
Top Products
79
[Preparation]
Preparation
Initialization of EEPROM
of the console starts.
Copying of parameters
from the driver to the console starts.
Writing of parameters
into the console EEPROM starts.
• • • • •
Numeral decreases
as time passes.
Copying completes normally.
Error display
<Remarks>
If error is displayed, repeat
the procedures from the
beginning.
Press for releasing
error.
After copying finishes, return to SELECTION display, referring to structure of each mode (P.60 and 61)
<Remarks>
Don't disconnect the console from the driver between to
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.
<Note>
If the error display repeats frequently, check the broken cable, disconnection of the connector,
misoperation due to noise or failure of console.
Starting from initial LED status, Press five time after pressing ,
then press , to make a display to
Press to call for
EXECUTION DISPLAY of
Keep pressing until
the console display (LED)
changes to
“ ” increases by
pressing (approx. 3sec)
as the left fig. shows.
Copying Function (Console Only)
Copying of Parameters from the Driver to the Console
Operation at SELECTION display
Operation at EXECUTION display