Filter
Top Products
74
How to Use the Front Panel and Console
Automatic Offset Adjustment (Front Panel Only)
Automatically adjust the offset value of Pr52 (Velocity command offset) of analog velocity command input
(SPR/TRQR).
Adjustment finishes.
Automatic offset
adjustment finishes.
Error occurs.
• Press to call for EXECUTION display of
When you execute automatic offset adjustment, make command input to 0V,
then keep pressing until the display changes to .
<Notes>
This function is invalid at position control mode.
You cannot write the data only by executing automatic offset adjustment.
Execute a writing to EEPROM when you need to reflect the result afterward.
“ ”
increases by
pressing (approx. 5sec)
as the right fig. shows.
Automatic offset
adjustment starts.
(
Invalid mode is selected, or offset value
)
exceeds the setup range of Pr52.
Operation at SELECTION display
Operation at EXECUTION display