Filter
Top Products
80
How to Use the Front Panel and Console
Copying of Parameters from the Console to the Driver
Reading of EEPROM of the
console starts.
Copying of parameters from
the console to the driver starts.
Writing of parameters into
the driver EEPROM starts.
......Numeral decreases
as time passes.
Copying completes normally.
Error display
<Remarks>
If error is displayed, repeat the
procedures from the beginning.
Press for releasing error.
After copying finishes, return to SELECTION display, referring to structure of each mode (P.60 and 61).
<Remarks>
Don't disconnect the console from the driver between to
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.
<Note>
If the error display repeats frequently, check the broken cable, disconnection of the connector,
misoperation due to noise or failure of console.
Starting from initial LED status,
Press five time after pressing , then press
to make a display to
Press to call for
EXECUTION DISPLAY of
Keep pressing until
the console display (LED)
changes to
“ ” increases by
pressing (approx. 3sec)
as the left fig. shows.
Operation at SELECTION display
Operation at EXECUTION display