Filter
Top Products
MN102HF75K Flash EEPROM Version
Using the Onboard Serial Programming Mode
MN102H75K/F75K/85K/F85K LSI User Manual Panasonic Semiconductor Development Company
323
Panasonic
B.4.4 Microcontroller Memory Map Used During Onboard
Serial Programming
B.4.4.1 Flash ROM Address Space
■
Serial writer load program area
This kilobyte of ROM, starting at address x’0x80000’, holds the load program
for the serial writer. This area is write-protected in the hardware. Panasonic
provides the load program.
■
Fixed user program area
These 7 kilobytes of ROM starting at address x’0x80400’, hold the fixed user
program. This area is write-protected in the hardware. (You can program this area
with a parallel writer.)
■
Security code
This byte holds the password for the serial writer. Enter an 8-character ASCII
code in this space.
■
Reserved area
Do not write to this area.
■
Branch instruction to reset service routine
Normally, reset servicing starts at address x’0x80000’, but the soft branch
instruction in the serial writer load program branches to x’0x82010’. This
address must hold a JMP instruction pointing to the real start address for the reset
service routine.
Table B-4 Flash ROM Address Space in Serial Programming Mode
Address Size Description
x’0x80000’
|
x’0x803FF’
1 KB Serial writer load program area
x’0x80400’
|
|
x’0x81FFF’
7 KB Fixed user program area
x’0x82000’
|
x’0x82007’
8 bytes Security code
x’0x82008’
|
x’0x8200F’
8 bytes Reserved area
x’0x82010’
|
x’0x82017’
8 bytes Branch instruction to reset service routine
(Ex., JMP 82100)
x’0x82018’
|
x’0x8201F’
8 bytes Branch instruction to interrupt service routine
(Ex., JMP 82200)
x’0x82020’
|
|
x’0xBFFFF’
248 KB User program area