Filter
Top Products
Chapter 5 Volume Management
5.2 Functions in the Action Area for Volume
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
145
The procedure to initialize an SDV is as follows:
Procedure
1 Select the SDV to be initialized (multiple selections can be made) and click [Initialize SDV]
in [Action].
→ A confirmation screen appears.
2 Click the [OK] button.
→ Initialization of the SDV starts.
3 Click the [Done] button to return to the [Volume] screen.
End of procedure
5.2.15 Encrypt Volume
This function encrypts existing volumes.
• When using this function, enable the encryption mode. Refer to "11.2.13.5 Setup Encryption Mode" (page
941) for details.
• This function is used to prevent data leakage due to removal of disks, and cannot prevent data leakage
caused by server access.
• Encrypted volumes cannot be changed to non-encrypted volumes.
• "Standard", "WSV", and "SDV" type volumes can be encrypted.
• Canceling volume encryption is not possible.
• This function cannot be used under the following conditions:
- When a RAID group diagnosis is being performed
- When a disk diagnosis is being performed
- When firmware is being switched in hot mode
- When disk firmware is being applied
- When the status of the ETERNUS DX Disk storage system is other than "Normal"