Fujitsu DX440 S2 Computer Drive User Manual


  Open as PDF
of 1066
 
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
533
Set Loop ID
When "Connection" is "FC-AL", select "Manual" or "Auto" as the specification method for the Loop ID.
"Loop ID" is an identification number of a node in a loop.
Loop ID
- Manual
When the "Set Loop ID" is "Manual", enter the Loop ID.
The Loop ID must have a value that is different from the values of all the ports.
The following input condition applies:
0x0 - 0x7D
- Auto
When the "Set Loop ID" is "Auto", select "Ascending" or "Descending".
Transfer Rate
Select the transfer speed for the target port. The available transfer rate varies according to the
selected port type and connection topology.
- Auto-negotiation
- 1 Gbit/s (Not supported)
- 2 Gbit/s (Not supported when "Type" is "16G FC")
- 4 Gbit/s
- 8 Gbit/s
- 16 Gbit/s (Not supported when "Type" is "8G FC" or when "Type" is "16G FC" and "Connection" is
"FC-AL")
Frame Size
Select the frame size of the target port.
"Frame Size" specifies the length of the communication information.
- 512 bytes
- 1024 bytes
- 2048 bytes
Reset Scope
Specify the reset scope of the target port.
Reset scope is the range where the command reset from the server is performed, when the target
port is connected to multiple servers.
- I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset request.
- T_L (T: Target, L: LUN)
Reset (cancels) the command request from all of the servers that are connected to the port.
Select "Fabric" for a direct connection when "Transfer Rate" is "16 Gbit/s".
Select "Auto-negotiation", "2 Gbit/s", "4 Gbit/s", "8 Gbit/s", or "16 Gbit/s" for "Transfer Rate". Note
that "1 Gbit/s" is not supported.
"Auto-negotiation" is selected for "Transfer Rate" when "Type" is "16G FC", "Transfer Rate" is "16
Gbit/s", and "Connection" is changed from "Fabric" to "FC-AL".