Filter
Top Products
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
562
■ When the port mode is "iSCSI-RA (for older storage system connection)"
When the type is "iSCSI-RA (for older storage system connection)", specify the following items:
● Port Settings
• Port
Select the target port.
The selectable port locations are displayed as options:
- CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)
● TCP/IP Settings
• IP Address
Input the IP address of the target port (required).
Click the [Test Connection (ping)] button to display the "[Send Ping Command] Screen" (page 565)
.
Specify the IP address to check the connection status of the connection destination storage system
and the number of transmissions. Click the [Send] button. When the "ping" command is sent, the
settings of the IP address and the connection path for the destination storage system can be
checked.
The following input conditions apply:
- Up to 3 numeric characters
- First text box: "1" - "255"
- Other text boxes: "0" - "255"
• Subnet Mask
Input the subnet mask of the target port (required).
The following input conditions apply:
- Up to 3 numeric characters
- All text boxes: "0" - "255"
• Gateway
Input the gateway IP address of the target port.
- Up to 3 numeric characters
- All text boxes: "0" - "255"
● iSCSI Settings
• Alias Name
Input the Alias Name of the target port.
While the iSCSI name is a formal nomenclature that specifies the target iSCSI port, an Alias Name is
used as nickname.
An Alias Name that is the same as another port cannot be specified.
The following input condition applies:
- Up to 31 alphanumeric characters
Older storage systems do not support IPv6. Make sure to specify IPv4 addresses.