Fujitsu DX440 S2 Computer Drive User Manual


  Open as PDF
of 1066
 
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
449
The procedure to create an iSCSI host group is as follows:
Procedure
1 Click [Add iSCSI Host Group] in [Action].
2 Input a host group name to be created, and select a host response to be assigned to the
host group.
Host Group Name
Specify the host group name.
An existing host group name cannot be specified. Refer to "Naming conventions for adding hosts"
(page 994) for details.
The following input conditions apply:
- Up to 16 alphanumeric characters and symbols (except ", (comma)" and "?")
- Space
Host Response
Select a host response to be assigned to a host group.
The host response list created in the ETERNUS DX Disk storage system is displayed.
- Solaris MPxIO
- HP-UX
- AIX EMPD (*1)
- AIX VxVM
- AIX Single Path
- VS850/SVC
- Host responses created in the ETERNUS DX Disk storage system
- Default
*1: EMPD: ETERNUS Multipath Driver
Unlike GUI, CLI can register two iSCSI hosts that have the same iSCSI name by setting an IP address for one
of these iSCSI hosts and by not setting an IP address for the other iSCSI host. However, if iSCSI hosts are
registered in the ETERNUS DX Disk storage system in this way, iSCSI hosts cannot be added using GUI.
Avoid this configuration when using GUI and CLI together. If both iSCSI hosts already exist, use CLI to
specify an IP address for the iSCSI host without the IP address.
The name of the [Add iSCSI Host] function, which creates a new iSCSI host group and registers the mem-
ber hosts has changed with firmware version V10L50. The [Add iSCSI Host] function is now called the
[Add iSCSI Host Group] function.
To change the settings of the host groups, use the procedure in "9.2.2.5 Modify Host Group" (page 463).
To add a port to an existing host group, use the procedure in "9.2.2.5 Modify Host Group" (page 463)
.
To change the iSCSI host information, use the procedure in "9.2.2.16 Modify iSCSI Host" (page 509)
.