Fujitsu DX440 S2 Computer Drive User Manual


  Open as PDF
of 1066
 
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
569
9.2.3.10 Modify FCoE Port Parameters
This function sets the connection information for the FCoE ports that connect the ETERNUS DX Disk storage
system and the host.
The procedure to set FCoE port parameters is as follows:
Procedure
1 Select the FCoE port to set the parameters for (multiple selections can be made) and click
[Configure FCoE Port] in [Action].
2 Set the parameters for all of the selected ports and click the [Set] button.
Port
Select the target port or select the copy source port.
The selectable port location options are displayed as options:
- CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)
Transfer Rate (Gbit/s)
Set the transfer speed of the target port.
- 10Gbit/s
Set VLAN ID
Specify "Auto" to enable the automatic setting for the VLAN ID of the target port. Specify "Fixed" to
enable the fixed setting.
When "Auto" is specified, VLAN ID is automatically obtained and no need to specify the VLAN ID.
When "Fixed" is specified, specify the VLAN ID.
VLAN ID
Input the VLAN ID for the target port between 0 and 4095.
Make sure to set the same value for the VLAN ID as the VLAN ID of the FCoE switch that is to be
connected to.
When changing port parameters during operation, stop access from the server that is allocated to the target
port. Host access does not need to be stopped to change the port parameters of newly added CA ports.
For more details on FCoE parameter settings, refer to "User’s Guide -Server Connection-" for each OS type.
Multiple selections can be made for the FCoE ports. To set the same parameters for multiple ports, set
the parameters of the copy source port and click the [Copy] button. Select the copy destination port
and click the [Copy] button. The parameters can be copied.
To set different parameters to multiple ports, select each target port and set the parameters.