Filter
Top Products
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
613
4 Click the [Done] button to return to the [iSCSI Port QoS] screen.
End of procedure
9.2.7.11 Set SAS Port QoS
This function specifies the bandwidth limit (maximum performance limit) for the SAS port.
The procedure to set the SAS port QoS is as follows:
Procedure
1 Select the SAS port to set the bandwidth limit (multiple selections can be made), and click
[Set SAS Port QoS] in [Action].
This function can be used, irrespective of whether the Host-LU QoS is enabled or disabled. However, if the
Host-LU QoS has been disabled, the host starts operating within the configured bandwidth limit after the
Host-LU QoS is enabled.
• Configure the port bandwidth limit on each host. Refer to the following sections for details:
- "9.2.7.6 Set FC/FCoE Host QoS" (page 605)
- "9.2.7.7 Set iSCSI Host QoS" (page 607)
- "9.2.7.8 Set SAS Host QoS" (page 608)
• The LUN bandwidth limit can be configured in the LU QoS group. Refer to "9.2.7.2 Set Host-LU QoS" (page
599) for details.