Fujitsu DX440 S2 Computer Drive User Manual


  Open as PDF
of 1066
 
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
481
The procedure to edit a SAS host group is as follows:
Procedure
1 Select the SAS host group to be changed, and click [Modify Host Group] in [Action].
2 Input a new host group name, or re-select a host response to be assigned to the host group.
Host Group Setting
Host Group Name
Specify the host group name.
An existing host group name cannot be specified. Refer to "Naming conventions for adding hosts"
(page 994) for details.
The following input conditions apply:
- Up to 16 alphanumeric characters and symbols (except ", (comma)" and "?")
- Space
Host Response
Select a host response to be assigned to a host group.
The host response list created in the ETERNUS DX Disk storage system is displayed.
- Solaris MPxIO
- HP-UX
- AIX EMPD (*1)
- AIX VxVM
- AIX Single Path
- VS850/SVC
- Host responses created in the ETERNUS DX Disk storage system
- Default
*1: EMPD: ETERNUS Multipath Driver
When a host was added to a host group, of which the host affinity setting has been configured, paths
between all the ports with the host affinity setting and the added host will be configured. To modify the
path between a host and a port, refer to "9.2.1.3 Modify Host Affinity" (page 428)
.
When a host in the host group for which the host affinity settings are already configured is deleted, the
path from the host to the port is also deleted.
To change the host group name or the SAS address, use the procedure in "9.2.2.17 Modify SAS Host"
(page 514).
To create a new host group and register hosts, use the procedure in "9.2.2.3 Add SAS Host Group" (page
456).