Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
774
6 Click the [OK] button.
→ Setting of the SNMP Agent Community starts.
7 Click the [Done] button to return to the [Network] screen.
End of procedure
11.2.3.8 Setup SNMP Agent Trap
This function notifies events that occur in the ETERNUS DX Disk storage system to the SNMP Manager by an
SNMP Trap.
This function configures the trap destination, the trap version, etc.
Up to ten traps can be specified for each ETERNUS DX Disk storage system.
The procedure to set the SNMP Agent trap is as follows:
Procedure
1 Click [Setup SNMP Trap] in [Action].
• If the "SNMP Function" is disabled, the [Setup SNMP Manager] function cannot be used.
• When SNMP Manager exists in a different subnetwork from where the ETERNUS DX Disk storage system
belongs, specify the IP address or the network address of SNMP Manager in the "Allowed IP List" using the
procedure in "11.2.3.1 Setup Network Environment" (page 745)
.