Fujitsu DX440 S2 Computer Drive User Manual


  Open as PDF
of 1066
 
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
803
Connection check operator
Select "Notification (Standard E-Mail format)", "Notification (Simple E-Mail format for cell phone)"
or "Not Notification" for the connection check operator of the setting confirmation result at the
REMCS center.
If notifying, input the "Connection check operator E-Mail Address".
Specify the "Connection check operator" if there is another person who needs to be notified of the
setting confirmation result, other than the administrator.
Connection check operator E-Mail Address
If notifying the connection check operator of the setting confirmation result at the REMCS center,
input the E-mail address.
The following input condition applies:
- Up to 60 alphanumeric characters and symbols (except space)
Time Information
SMTP Response Timeout (sec.)
Input the timeout limit when using SMTP connection.
The following input condition applies:
- Numeric characters ("1" - "3600")
SMTP Retry Count
Input the retry number of SMTP.
The following input condition applies:
- Numeric characters ("1" - "60")
SMTP Retry Interval (sec.)
Input the intervals for retrying SMTP.
The following input condition applies:
- Numeric characters ("1" - "3600")
HTTP Timeout (sec.)
Input the timeout limit when using HTTP connection.
The following input condition applies:
- Numeric characters ("1" - "3600")
HTTP Retry Count
Input the retry number of HTTP.
The following input condition applies:
- Numeric characters ("1" - "60")
HTTP Retry Interval (sec.)
Input the intervals for retrying HTTP.
The following input condition applies:
- Numeric characters ("1" - "3600")
Queue Time before Sending Mails (msec.) (only when POP Before SMTP authentication is enabled)
Input the waiting time for sending mail.
The following input condition applies:
- Numeric characters ("1" - "3600")
The timer parameter settings do not normally require modification.
If changing the default value, select the "Change following Timing Parameter items" checkbox.