Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
814
4 Click the [Done] button to return to the screen when starting this function in Step 1.
End of procedure
11.2.4.5 Setup Log Sending Parameters
This function transfers the internal log of the ETERNUS DX Disk storage system to the REMCS center.
There are two log sending methods: "Automatic" and "Manual".
• Configure Automatic Log Transmission
The ETERNUS DX Disk storage system sends log periodically or when an event occurs.
• Immediately Send Log Manually
The log is sent manually.
The procedure to send log is as follows:
■ Configure Automatic Log Transmission
The ETERNUS DX Disk storage system sends log periodically or when an event occurs.
Procedure
1 Click [Setup Log Sending Parameters] in [Action].
2 Specify the parameters, and click the [Set] button.
● Send Log based on Events
• Send Log when Errors Occur
To send logs automatically in the case of a failure, select the "Send" checkbox. The default state of
"Send Log when Errors Occur" setting is, if the Remote Support setting using the [Setup Remote
Support] function has been completed, "Send" will be enabled.
After completing the setting, the REMCS center sends the setting confirmation result to the
"Administrator E-Mail Address" or the "Connection check operator E-Mail Address". Make sure to
confirm the setting results.
This function cannot be used under the following conditions:
• When the procedure in "11.2.4.2 Setup Remote Support" (page 800)
is not performed.
• When a problem is detected in the Remote Support settings
• When the "Receiver Mail Address" (REMCS center) is not specified for the Remote Support
• The Remote Support is stopped