Filter
Top Products
Chapter 6 RAID Group Management
6.2 Functions in the Action Area for RAID Group
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
195
3 Click the [OK] button.
→ Setting of the ECO mode schedule starts.
4 Click the [Done] button to return to the [RAID Group] screen.
End of procedure
6.2.8 Set Key Group (RAID Group)
This function registers or deletes any RAID groups that are configured with SEDs in the key group.
The key group combines all of the RAID groups that use the same SED authentication key.
RAID groups in the key group are managed by the SED authentication key that is obtained from the key
server. One key group can be created in the ETERNUS DX Disk storage system.
If a RAID group is not registered in the key group, the RAID group is managed by the common key.
When registering RAID groups in the key group, perform the following settings:
• Create a key group.
• Allocate the master server or the slave server to the key group.
• Set the key for the key group and confirm that the key status is "Normal".
Refer to "11.2.6.6 Create Key Group" (page 841)
and "11.2.6.9 Update SED Authentication Key" (page 849)
for details.
• Information on the RAID groups that are configured by SEDs and registration status to the key group can
be checked in the [SED Key Group] screen. Refer to "6.1.4 SED Key Group" (page 167)
for details.
• Use the [Key Group] screen to check the SED authentication key information and the SSL/KMIP certificate
information that is used for the key group. Refer to "11.1.5.1 Key Group" (page 723)
for details.
• Even when operations are being performed for volumes that configure a key management target RAID
group, this RAID group can be added to or deleted from the key group.