Filter
Top Products
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
514
9.2.2.17 Modify SAS Host
This function changes the SAS host information.
The procedure to change the SAS host information is as follows:
Procedure
1 Select the SAS host to changed the host information for, and click [Modify SAS Host] in
[Action].
2 Input new host information and click the [Modify] button.
• Name
Input a new SAS host name. An existing host name cannot be specified.
The following input conditions apply:
- Up to 16 alphanumeric characters and symbols (except ", (comma)" and "?")
- Space
• SAS Address
Input a new SAS address. The same SAS address as another host cannot be used.
The following input conditions apply:
- 16 hexadecimal numbers
- "F (f)" or "0" used in entire 16 characters are not allowed.
• When no SAS hosts are registered, the [Modify SAS Host] function cannot be used.
• When changing the SAS address of a SAS host that is currently being used, make sure to stop access to
that SAS host.
• The [Rename SAS Host] function that is provided with controller firmware version V10L24 or earlier is
integrated in this function. Note that this function cannot change multiple SAS host names. Change one
SAS host name at a time.
• This function can change the following SAS host information; "Name" and "SAS Address". When the SAS
host is not registered in a host group, the "Host Response" setting can also be changed.
• When the SAS host is registered in a host group, use the [Modify Host Group] function to change the host
response. Refer to "9.2.2.8 Modify Host Group (SAS)" (page 480)
for details.