Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
899
11.2.9.4 Export Panic Dump
"Panic Dump" is the action of outputting (dump) memory information when an error (panic) occurs, and also
the name of the output information itself. This function exports and saves the memory information of the
Controller Module that is stored in the panic dump data, in a segment size specified by the user. An exported
panic dump can be stored on a floppy disk or hard disk, or sent by E-mail.
Panic dump is used to analyze the cause of a firmware abnormality or hardware error.
The procedure to export the panic dump is as follows:
Procedure
1 Click [Export Panic Dump] in [Action].
2 Specify the panic dump to be exported and the segment file size, and click the [Export]
button.
• Panic Dumps
Select a checkbox for the panic dump to be exported (only one panic dump can be selected).
• Dump File Segment Size
Select the file size (segment size) when saving the exported panic dump from the following:
- Non-segmentation
- 4.27MB
- 1.44MB (Floppy Disk)
- 640KB (E-Mail)
→ A confirmation screen appears.
• This function cannot be used when there is no panic dump to be exported in the ETERNUS DX Disk storage
system.
• Up to two panic dumps can be stored in a single CM.