Filter
Top Products
Chapter 3 Peak Detection and Labeling
3-16 Applied Biosystems
3
Setting Peak
Processing
parameters
(spectrum data
only)
To set Peak Processing parameters:
1. Click the Peak Processing tab in the Spectrum Peak
Detection Setup dialog box.
The Peak Processing tab is displayed (Figure 3-5).
Figure 3-5 Spectrum Peak Detection Setup—
Peak Processing Tab
NOTE: You can enable the %BP Intensity Threshold
Cursor and click-drag it to adjust the %Base Peak
Intensity.
2. Set parameters as needed, then click Apply to accept the
parameters and leave the dialog box open, or click OK to
accept the parameters and close the dialog box.
For a description of the parameters, see “Peak
Processing parameters (spectrum data only)” on
page 3-26.