Filter
Top Products
- 113 -
Syntax
show ipv6 mld snooping querier detail
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
MLD Snooping Querier Mode: Administrative mode for MLD Snooping. The default is disable
Querier Address: Specify the Snooping Querier Address to be used as source address in periodic
MLD queries. This address is used when no address is configured on the VLAN on which query is
being sent.
MLD Version: Specify the MLD protocol version used in periodic IGMP queries.
Querier Query Interval: Specify the time interval in seconds between periodic queries sent by the
snooping querier. The Query Interval must be a value in the range of 1 and 1800. The default value is
60.
Querier Expiry Interval: Specify the time interval in seconds after which the last querier information
is removed. The Querier Expiry Interval must be a value in the range of 60 and 300. The default value
is 60.
7.2.9.4 ipv6 mld snooping querier
The user can go to the CLI Global Configuration Mode to set MLD snooping querier admin mode, use the
ipv6 mld snooping querier global configuration command. Use the no ipv6 mld snooping querier to
disable.
Syntax
ipv6 mld snooping querier
no ipv6 mld snooping querier
Default Setting
Disabled
Command Mode
Global Config