- 318 -
switchport protected <0-2>
no switchport protected <0-2>
no - This command uses to configure a port as unprotected.
Default Setting
None
Command Mode
Interface Config
7.16 Static MAC Filtering Commands
7.16.1 Show Commands
7.16.1.1 show mac-address-table static
This command displays the Static MAC Filtering information for all Static MAC Filters. If you select <all>,
all the Static MAC Filters in the system are displayed. If you supply a value for <macaddr>, you must also
enter a value for <vlanid>, and the system displays Static MAC Filter information only for that MAC
address and VLAN.
Syntax
show mac-address-table static {<macaddr> <1-3965> | all}
<macaddr> - Static MAC address.
Default Setting
None
Command Mode
Privileged Exec
Display Message
MAC Address: Is the MAC Address of the static MAC filter entry.
VLAN ID: Is the VLAN ID of the static MAC filter entry.
Source Port(s): Indicates the source port filter set's slot and port(s).