Filter
Top Products
- 799 -
11.4.3.4 Configuring Area Range
Selection Criteria
Area ID - Selects the area for which data is to be configured.
Configurable Data
IP address - Enter the IP Address for the address range for the selected area.
Subnet Mask - Enter the Subnet Mask for the address range for the selected area.
LSDB Type - Select the type of Link Advertisement associated with the specified area and address
range. The default type is 'Network Summary'.
Advertisement - Select enable or disable from the pulldown menu. If you selected enable the
address range will be advertised outside the area via a Network Summary LSA. The default is enable.
Non-Configurable Data
Area ID - The OSPF area.
IP address - The IP Address of an address range for the area.
Subnet Mask - The Subnet Mask of an address range for the area.
LSDB Type - The Link Advertisement type for the address range and area.
Advertisement - The Advertisement mode for the address range and area.
Command Buttons
Create - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
The new address range will be added to the display in the non-configurable data area.
Delete - Removes the specified address range from the area configuration.
11.4.3.5 View Interface Statistics
This panel displays statistics for the selected interface. The information will be displayed only if OSPF is
enabled.