Filter
Top Products
- 605 -
10.6.2.2 ipv6 pimdm hello-interval
Use this command to configure the PIM-DM hello interval for the specified router interface. The
hello-interval is specified in seconds and is in the range 30–3600.
Syntax
ipv6 pimdm hello-interval <30-3600>
no ipv6 pimdm hello-interval
no - Use this command to set the PIM-DM hello interval to the default value.
Default Setting
Disabled
Command Mode
Interface Config
10.7 Protocol Independent Multicast – Sparse Mode (PIM-SM) Commands
10.7.1 Show Commands
10.7.1.1 show ipv6 pimsm
This command displays the system-wide information for PIM-SM.
Syntax
show ipv6 pimsm
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Admin Mode: Indicates whether PIM-SM is enabled or disabled.
Data Threshold Rate (Kbps): The data threshold rate for the PIM-SM router.
Register Threshold Rate (Kbps): The threshold rate for the RP router to switch to the shortest path.
SSM Range Table Group Address/Prefix Length
PIM-SM Interface Status: