Filter
Top Products
- 156 -
Command Mode
Interface-Vlan Config
Command Usage
Once the IP address is set, the VLAN ID’s value will be assigned to management VLAN.
7.3.1.6 ip default-gateway
This command sets the IP Address of the default gateway.
Syntax
ip default-gateway <gateway>
no ip default-gateway
< gateway > - IP address of the default gateway
no - Restore the default IP address of the default gateway
Default Setting
IP address: 0.0.0.0
Command Mode
Global Config
7.3.1.7 ip address protocol
This command specifies the network configuration protocol to be used. If you modify this value, the
change is effective immediately.
Syntax
ip address protocol {bootp | dhcp | none}
<bootp> - Obtains IP address from BOOTP.
<dhcp> - Obtains IP address from DHCP.
<none> - Obtains IP address by setting configuration.
Default Setting
None
Command Mode
Interface-Vlan Config