- 611 -
10.7.2.5 ipv6 pimsm rp-candidate
This command is used to configure the router to advertise itself as a PIM candidate rendezvous point
(RP) to the bootstrap router (BSR).
Syntax
ipv6 pimsm rp-candidate interface <slot/port> <group-address> <group-mask>
no ipv6 pimsm rp-candidate interface <slot/port> <group-address> <group-mask>
no - This command is used to disable the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Default Setting
0
Command Mode
Global Config
10.7.2.6 ipv6 pimsm spt-threshold
This command is used to configure the Data Threshold rate for the last-hop router to switch to the shortest
path. The rate is specified in Kilobits per second. The possible values are 0 to 2000.
Syntax
iipv6 pimsm spt-threshold <1-2000>
no ipv6 pimsm spt-threshold
no - This command is used to set the Data Threshold rate for the RP router to the default value.
Default Setting
0
Command Mode
Global Config
10.7.2.7 ipv6 pimsm ssm
Use this command to define the Source Specific Multicast (SSM) range of IP multicast addresses.
Syntax
ipv6 pimsm ssm {default | <group-address> <group-mask>}
no ipv6 pimsm ssm