- 579 -
Retransmit Interval: Is the configured retransmit interval for the OSPFv3 virtual interface.
Transit Delay: Is the configured transit delay for the OSPFv3 virtual interface.
10.4.2 Configuration Commands
10.4.2.1 ipv6 ospf
This command enables OSPF on a router interface or loopback interface.
Syntax
ipv6 ospf
no ipv6 ospf
<no> - This command disables OSPF on a router interface or loopback interface.
Default Setting
Disabled
Command Mode
Interface Config
10.4.2.2 ipv6 ospf areaid
This command sets the OSPF area to which the specified router interface belongs. The <areaid> is an
IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value in the range of
<0-4294967295>. The <areaid> uniquely identifies the area to which the interface connects. Assigning an
area id, which does not exist on an interface, causes the area to be created with default values.
Syntax
ipv6 ospf areaid <areaid>
<areaid> - is an IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value in the
range of <0-4294967295>.
Default Setting
None
Command Mode
Interface Config