Filter
Top Products
- 219 -
no - This command sets the Edgeport function to the default value, that is Enabled.
Default Setting
Enabled
Command Mode
Global Config
This command specifies that this port is an Edge Port within the common and internal spanning tree. This
will allow this port to transition to Forwarding State without delay.
Syntax
spanning-tree edgeport
no spanning-tree edgeport
no - This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Default Setting
None
Command Mode
Interface Config
This command sets the Edgeport BPDU Filter enable/disable parameter for sending/receiving BPDUs on
this switch. This command only works on dot1d mode.
Syntax
spanning-tree edgeport bpdufilter
no spanning-tree edgeport bpdufilter
no - This command sets the Edgeport BPDU Filter to the default value, that is Disabled.
Default Setting
Disabled
Command Mode
Global Config