- 595 -
10.4.2.34 maximum-paths
This command sets the number of paths that OSPF can report for a given destination where <maxpaths>
is platform dependent.
Syntax
maximum-paths <1-2>
no maximum-paths
<1-2> - The maximum number of paths that OSPF can report for a given destination. The range of the
value is 1 to 2.
no - This command resets the number of paths that OSPF can report for a given destination back to
its default value.
Default Setting
1
Command Mode
Router OSPFv3 Config.
10.4.2.35 passive-interface default
Use this command to enable global passive mode by default for all interfaces. It overrides any interface
level passive mode.OSPF shall not form adjacencies over a passive interface.
Syntax
passive-interface default
no passive-interface default
Default Setting
Disabled
Command Mode
Router OSPFv3 Config.
10.4.2.36 passive-interface
Use this command to set the interface or tunnel as passive. It overrides the global passive mode that is
currently effective on the interface or tunnel.
Syntax