- 95 -
When you specify a value for <vlanid>, the following information appears.
VLAN ID: VLAN Id
IGMP Snooping Admin Mode: Indicates whether IGMP Snooping is active on the VLAN.
Fast Leave Mode: Indicates whether IGMP Snooping Fast Leave is active on the VLAN.
Group Membership Interval: Shows the amount of time in seconds that a switch will wait for a report
from a particular group on a particular interface, which is participating in the VLAN, before deleting the
interface from the entry. This value may be configured.
Max Response Time: VLANs on which IGMP Snooping is enabled.
Multicast Router Expiry Time: Displays the amount of time to wait before removing an interface that
is participating in the VLAN from the list of interfaces with multicast routers attached. The interface is
removed if a query is not received. This value may be configured.
7.2.6.15 show ip igmp snooping mrouter interface
The user can go to the CLI Privilege Exec to display information about statically configured multicast
router-attached interfaces, use the show ip igmp snooping mrouter interface Privilege command.
Syntax
show ip igmp snooping mrouter interface <slot/port>
<slot/port> - Interface number.
Default Setting
None
Command Mode
Privilege Exec
Display Message
Slot/Port: Shows the interface on which multicast router information is being displayed.
Multicast Router Attached: Indicates whether multicast router is statically enabled on the interface.
7.2.6.16 show ip igmp snooping mrouter vlan
The user can go to the CLI Privilege Exec to display information about statically configured multicast
router-attached interfaces, use the show ip igmp snooping mrouter vlan Privilege command.
Syntax
show ip igmp snooping mrouter vlan <slot/port>