Filter
Top Products
- 54 -
7.2.1.9 storm-control flowcontrol pfc
The PFC function is disabled by default. Only after enabling it, the PFC process also starts.
Once the feature is enabled, the original basic IEEE 802.3x PAUSE control cannot be enabled.
It means these two features cannot be enabled at the same time.
i
802.3x flow control only applies to full-duplex mode ports.
Syntax
storm-control flowcontrol pfc
no storm-control flowcontrol pfc
no - This command disables Priority Flow Control for the specific interface.
Default Setting
Disabled
Command Mode
Interface Config
7.2.1.10 shutdown
This command is used to disable a port.
Syntax
shutdown
no shutdown
no - This command enables a port.
Default Setting
Enabled
Command Mode
Interface Config
This command is used to disable all ports.
Syntax
shutdown all
no shutdown all
all - This command represents all ports.