5. If necessary to better access the area, remove the toroid from the cable. To remove the
toroid, lift up on the strip (1) and swing the top cover (2) open and then remove the
toroid from the wires.
Figure 6-7.
Left front cover removal (2 of 4)
6. Unhook one claw (3) from the bottom of the cover and pull out the bottom of the cover to
loosen it.
Reinstallation tip
Remember to put the switch rod back into the switch button.
Figure 6-8.
Left front cover removal (2 of 3)
212 Chapter 6 Removal and replacement ENWW