11. Press the black ridges on the front of the fuser until the fuser clicks into place.
12. To reattach the lower rear door (rear output bin), hold the door at a 45-degree angle,
and fit the peg into the round hole on the right side.
13. Press the ridges on the tab on the left side of the door, and fit the peg into the round hole.
14. Close the lower rear door (rear output bin). Turn the printer on.
Lower rear door area jams (area 6)
1. Open the lower rear door (rear output bin).
376 Chapter 7 Troubleshooting ENWW