Filter
Top Products
Menu item Values Description
OPTIMIZE T1 UP
T1 DOWN
T2 UP 1
T2 UP 2
T2 DOWN 1
T2 DOWN 2
LEADING EDGE UP
LEADING EDGE
DOWN
REDUCE
BKGROUND 1
REDUCE
BKGROUND 2
FUSER DOWN 1
FUSER DOWN 2
FILM OFFSET
GHOST
PREVENTION
PRE-ROTATION
RESTORE OPTIMIZE
Allows you to optimize
certain parameters for all
jobs rather than (or in
addition to) optimizing by
paper type. The default for
each item is OFF. RESTORE
OPTIMIZE resets all of the
values to OFF.
T1 UP - Use when toner
does not adequately transfer
from the print cartridge drum
to the ITB.
T1 DOWN - Use when toner
transfers unevenly from the
print cartridge drum to the ITB.
T2 UP 1 - Use when poor
transfer occurs on the entire
surface of the media from the
ITB to the paper at the
secondary transfer roller.
T2 UP 2 - Use when T2 UP 1
did not completely solve the
problem.
T2 DOWN 1 - Use when poor
transfer in black or freckles
appear on the entire surface
of the media, especially in
purple.
T2 DOWN 2 - Use when T2
DOWN 1 did not completely
solve the problem.
LEADING EDGE UP -
Unassigned.
LEADING EDGE DOWN -
Unassigned.
REDUCE BKGROUND 1 -
Unassigned.
REDUCE BKGROUND 2 -
Unassigned.
FUSER DOWN 1 - Use when
hot offset occurs (the image
repeats because toner sticks
to the fuser film instead of the
paper; toner gets transferred
to the paper later, in the
wrong place).
FUSER DOWN 2 - Use when
FUSER DOWN 1 did not
completely solve the problem.
Table 7-44. Print quality menu (continued)
ENWW Control panel troubleshooting 413