9. Disconnect one connector (1) and lift the primary transfer roller engaging motor (2) up
slightly, and then pull it to the left to remove it.
Figure 6-113.
Transfer roller engaging motor (4 of 4)
Exhaust fan (FAN1) removal
1. Remove the left cover. See Left cover removal.
2. Remove two connectors (1) from the DC controller PCB.
3. Unhook four claws (2) and pull the fan motor (3) out to remove it.
Figure 6-114.
Fan removal
Reinstallation tip
Be sure the arrow on the fan points to the outside when reinstalling the exhaust fan.
ENWW Motor and fans 277