3. Unhook two claws from the back and remove the sensor (4).
Figure 6-81.
Duplex feed delivery paper sensor removal
Rear output bin paper sensor (PS11) removal
1. Remove the face-down delivery assembly. See Face-down delivery assembly removal.
2. Disconnect one connector (1) and unhook two claws (2). To unhook the claws, insert a
pointed object into the two claw locations (2), (under the sensor at the connector side of
the sensor), to release the claws, then lift up on the connector side of the sensor (3) to
remove it.
Figure 6-82.
Rear output bin paper sensor removal
ENWW Sensors 259