7. Remove the motor cover (4) by pressing down on the tab (5) while pulling the cover
slightly to the left and up, then pull it and out to remove it.
Figure 6-111.
Primary transfer roller engaging motor removal (2 of 4)
8. Remove the gear (1) and then remove two screws that secure the motor.
Reinstallation tip
When reinstalling the gear (1), insert the gear with shaft that was removed in the
previous step (callout (3) in the figure above) from inside the printer, through this gear.
Figure 6-112.
Transfer roller engaging motor removal (3 of 4)
276 Chapter 6 Removal and replacement ENWW