3. Unhook two claws (1), disconnect one connector (2), and remove the registration paper
sensor (3) from the sensor holder.
Figure 6-73.
Registration paper sensor removal (2 of 2)
Media sensor (PS5) removal
NOTE
When the media sensor is replaced, in addition to replacing the sensor, a configuration
procedure must be performed. For information on this configuration, refer to Chapter 8,
Replacement parts configuration.
1. Remove the color misregistration sensor. See
Color misregistration sensor (PS12)
removal.
2. Disconnect one connector (1).
3. Swing the front side of the media sensor upward (2), then lift the sensor (4) up, removing
it from the two shafts (3).
Figure 6-74.
Media sensor removal
ENWW Sensors 255