4. Remove three screws (1) and swing the cable harness (2) to the right. The cable
harness does not need to be completely removed to remove the transfer contact
assembly. However, if the cable harness needs to be removed, disconnect the cable
connector (3) from the back of the harness to remove the harness.
Reinstallation tip
The power switch rod (4) rides in a slot at the bottom of the cable harness. When
reinstalling the cable harness, make sure the switch rod is inserted in this slot.
Figure 6-60.
Left swing guide removal (2 of 6)
5. Remove one screw (1) and unhook three claws (2) to remove the transfer contact
assembly (3).
Reinstallation tip
When installing the transfer contact assembly, make sure that the plastic tab (4) fits
under the metal tab (5) and that the door switch (SW1) is in place.
Figure 6-61.
Left swing guide removal (3 of 6)
246 Chapter 6 Removal and replacement ENWW