Filter
Top Products
8-24 SmartSwitch 1800 4.0 User Guide, Rev 01
Subscriber Parameters
1
The valid port numbers depend on the model of SmartSwitch 1800—see port locations
on page 6-1.
2 The software does not verify that a specified port exists. Make sure the port is configured
in the database.
Subscriber Name
identifies the subscriber to the console operator.
Routing Algorithm
allows creation of a "hunt group" of ports (see example on page 8-23), for the purpose
of routing per a pre-selected algorithm:
0
= Round Robin – selects ports specified cyclicly in numerical order according
to the list of Redirection Addresses. If the selected port is unreachable or con-
gested, the Call Request will be sent to the next port. (If the port becomes
available again, it will be included in its assigned position.)
1
= Alternate Route on Line Failure – selects the first port that is not in a failed
state. If the selected port does not make a connection, the call will be cleared, even
if other ports are available.
2
= Alternate Route on Line Busy – selects the first port that has LCNs available
(is not busy). If the port has failed, the next available port will be selected.
3
= Least LCN with Throughput – selects the line with the minumum loading, cal-
culated by weight and number of LCNs in use on that line. (Each line is assigned
a weight proportional to its throughput within the routing path.)
If use of a routing algorithm is not desired, simply accept the default, and specify only
one routing path.
Systematic Redirection
will redirect (if
Y
) all calls to Redirection Address 0. If that address cannot be reached
and
Redirect on Busy
and/or
Redirect on Out of Order
are set to
Y
, a call will be placed
to Redirection Address 1, then (if necessary) Redirection Address 2, and so on.
Table 8-3 Subscriber Parameters
Parameter Valid Values Default Value
Subscriber Name
0–31 characters none
Routing Algorithm 0–3 0
Systematic Redirection Y/N N
Redirect on Busy Y/N N
Redirect on Out of Order Y/N N
Connection Priority 0–9 0
1st,2nd,etc. Path Configured Y/N N
RLP n/a
0
Port
Physical port:
0–7
1, 2
Logical port:
8-63
2
0
Redirection Address 0,1,etc.
valid address none