Filter
Top Products
16-12 SmartSwitch 1800 4.0 User Guide, Rev 01
Configuring Bridge Ports
A Bridge port is a SmartSwitch 1800 LAN interface or frame relay port that will
operate as a bridge connection to the LAN or WAN.
Press
[C]
at the IP/LLC2/BRIDGE/IPX Interfaces Configuration Menu to display con-
figured Bridge ports.
Figure 16-4 Bridge Ports Display
[A],[C],[E],[C]
from Main Menu
These interfaces can be used for either LLC2 or Bridging. Also note
that the
RLP
column is irrelevant on the SmartSwitch 1800.
To configure an interface, press
[D]
at the IP/LLC2/BRIDGE/IPX Interfaces Config-
uration Menu. When prompted for an
Interface Number
(which is merely a sequential
number to identify the interface):
●
If modifying an existing record, enter the interface number:
0–95
.
Do not configure more than one interface per DLCI on a port.
●
If creating a new record, press
[Enter]
, which will automatically specify the next
available sequential interface number.
The display depends on the interface; the following figure shows an example, and
Table 16-8 lists the parameters for all interface types.
Node Name=node_xyz
Review Bridge Ports/LLC2 Interfaces
-------------------------------------------------------------------------------------------------------
Interface Number Type RLP Port DLCI Format
-------------------------------------------------------------------------------------------------------
0 Ethernet
1 Frame Relay 0 1 30 Native LLC-2
2 Frame Relay 0 1 31 8025_SRB
3 Frame Relay 0 1 32 8025_SRB
4 Frame Relay 0 1 33 8023_TB
PgUp, PgDn, F3:Exit, F9:Stop Remote, F10:Abort