Filter
Top Products
Introduction to Database Configuration 3-11
E On-Line Update IPX Filter Definitions and Applications
–
(Chapter 15) allows updating the SmartSwitch with any changes
without rebooting.
F Review Bridge Filter Definitions
– (Chapter 16) displays any
Bridge filters (see next item) that have been configured on the
SmartSwitch.
G Configure Bridge Filter Definitions
– (Chapter 16) specifies
parameters for regulation of bridge traffic by filtering MAC
addresses, NetBIOS names, SAP updates, etc.
H Review Bridge Filter Applications
– (Chapter 16) displays
information on any bridge filter applications (see below)
configured on the SmartSwitch.
I Configure Bridge Filter Applications
– (Chapter 16) applies
bridge filters to interfaces/filter types/directions.
J On-Line Update Bridge Filter Definitions and Applications
(Chapter 16) allows updating the SmartSwitch with any changes
without rebooting.
G On-Line Update Dynamic Routing Parameters
– (misc.) updates
the system memory with any changes that have been made to
routing parameters.
F Configure Async PAD Parameters
– (Chapter 12) defines operating
parameters for devices connected to SmartSwitch async PAD ports.
A Review Async PAD Profiles
B Configure Async PAD Profiles
C Review Async PAD Logins
D Configure Async PAD Logins
G Review Model Information
– displays the maximum number of
logical connections allowed, and lists the protocols installed, on the
SmartSwitch 1800.
H Configure Bandwidth Allocation Groups
– (Chapter 4) defines up
to 16 groups that assign connection priorities to various types of
traffic.
B Configure Protocols
(Chapter 5)
A Review Protocol Configuration
– displays installed protocols.
B Configure Protocols
– specifies the protocols that will be used.
C Display Memory Status
– displays a table showing available and
used memory.
C Configure Ports
A Configure RLP Ports
– (Chapter 6 through Chapter 12) specifies types
and operating parameters of serial ports.
B Configure LAN Port
– (Chapter 6) specifies the type (Ethernet or
Token Ring) and associated address for the LAN interface.
C X.25 Address Translation Templates
– (Chapter 8) displays, specifies,
and tests templates that are applied to incoming and outgoing call
packets for the purpose of translating selected fields of a packet that may
not otherwise be in a compatible format.
A Review X.25 Address Translation Templates
B Configure X.25 Address Translation Templates
C Test X.25 Address Translation Templates
D Configure Logical Ports
– (Chapter 8) specifies operating parameters
for logical ports residing on physical frame relay ports.