Cabletron Systems 1800 Switch User Manual


 
Configuring IPX 15-9
IPX Filter Applications Parameters
Permit
Determines whether the traffic defined by the
Filter "n"
entries will be permitted or
denied passage across the interface.
Filter "n"
corresponds to the
Filter ID
s in the IPX Filter Definitions file. (See page 15-3.)
Configuring IPX Interfaces
An IPX interface allows a SmartSwitch 1800 to connect to a Novell IPX network.
Press
[E]
at the IP/LLC2/BRIDGE/IPX Interfaces Configuration Menu
(or
[A], [C], [E],
[E]
from the Main Menu) to display configured IPX interfaces.
To configure an interface, press
[F]
at the IP/LLC2/BRIDGE/IPX Interfaces Configu-
ration Menu. When prompted, enter an
Interface Number
:
0–63
. (This is merely a
sequential number to identify the interface.)
The display depends on the interface; the following figure shows an example, and
Table 15-7 through Table 15-9 list the parameters for all interface types.
Figure 15-4 IPX Interface Record Example
[A],[C],[E],[F]
from Main Menu
Table 15-6 IPX Filter Applications Parameters
Parameter Valid Values Default Value
Permit Y/N N
Filter "n" 0–65535 0
IPX Interface Configuration
* Interface Number 2
A Blocked Port Flag N
B Interface Type Ethernet
C Frame Type TYPE_II
D Maximum Transmission Unit 4096
E IPX Network Address 00000001
F Pri or ity 0
G Bandwidth Allocation Group 1
H Port Diagnostics Enabled Y
I NetBIOS Enabled N
J NetBIOS Hops 8
K Periodic RIP Enabled Y
L Periodic RIP Timer (sec) 60
M Periodic SAP Enabled Y
N Periodic SAP Timer (sec) 60
O Additional IPX Parameters
Option: