Cabletron Systems 1800 Switch User Manual


 
Configuring X.25 8-27
To resolve any differences in addressing conventions, the backup path invokes a trans-
lation of the called and calling addresses. The SmartSwitch 1800-compatible called
and calling addresses are translated into PDN-compatible called and calling addresses.
Node 2 has a translation template defined to intercept packets with the PDN-com-
patible calling address for node 1. It translates these into the SmartSwitch 1800-com-
patible calling address for node 2. (The backup routing is transparent.)
To display existing translation templates, press
[A]
at the X.25 Address Translation
Templates Menu.
Figure 8-9 Address Translation Templates Display
[A],[C],[C],[A]
from Main Menu
The data between lines is structured to match the headings at the top of the
screen.
To add or change a translation template, press
[B]
at the X.25 Address Translation
Templates Menu and enter:
Port
. (The default is
0
.) Valid port numbers depend on the model of SmartSwitch
1800—see port locations on page 6-1.
Direction
,
I
(for incoming packets) or
O
(for outgoing packets). (The default is
I
.)
Template ID
, up to 31 characters (including the
G
and
U
separators described
below), in the format:
aaaaaaaaaaaaaGbbbbbbbbbbbbbbUddddddddddddddd
where:
aaaaaaaaaaaaaa
is up to 15 digits of called address,
G
is the letter "G," which precedes any calling address,
bbbbbbbbbbbbbb
is up to 15 digits of calling address,
U
is the letter "U," which precedes any user data, and
ddddddddddd
is a user data field of up to 12 numeric characters.
Node Name=nodexyz
P Dir Translation ID Translation Name
Calling Called User Data
Protocol ID Facilities
===================================================================
0 Incoming 3110*U* tempexamp1
P L1234 X123
PP
===================================================================
0 Incoming 1233751* tempexamp2
L200C011009 P P
01000000 P
===================================================================
PgUp,PgD n, F3:Exit, F9:Stop Remote, F10:Abort: