Filter
Top Products
21-8 SmartSwitch 1800 4.0 User Guide, Rev 01
The statistic names in this display are self-explanatory (except the
Version of DSP
Image
, which is not currently displayed.
Voice Connection Statistics
To display Voice Connection statistics for both Voice ports, press
[B]
at the Voice Sta-
tistics Displays Menu. When prompted, enter:
●
Port
:
4
or
5
.
●
Report Interval
:
5–65535
(seconds). (Default is
5
.)
Figure 21-8 Voice Connection Statistics Display
[E],[I],[B]
from Main Menu
As this manual was going to press, there was a possibility that the
above display would change to clarify the information shown for
Source
and
Destination
at the top of the screen. The correct descrip-
tions of those items are in the list below.
Information in this Display:
●
Source: RLP, Port
– Identifies the local Voice port. (
RLP
is irrelevant, and will
always be
0
.)
●
Destination: Node
– identifies the device at the remote end of the frame relay
connection.
●
Destination: RLP, Port, DLCI
– identify the local frame relay interface that will be
used to transport Voice frames.
●
Call State
– will be one of these:
On Hook
.
Off Hook
.
Call Active
– a call has been placed and answered
Pending
– the call has timed out during a busy condition, but the receiver is
still off hook.
Loading.
Node Name=node_xyz
Voice Connection Statistics Display
Source R LP: 0 Port: 5
Destination: Node: 110 R LP: 0
P or t: 0 DLCI: 1 6
Report Interval (sec): 5
Current Time: 01/07/1998 14:23:45
STATISTICS
Call State Id le
Frames Received from Network 100
Frames Transmitted to Network 110
Congestion Management from Network 0
Congestion Management to Network 0
Call Setup Time (msec) 100
Call Duration (secs) 1:14
Number Dialed 100100
Baud Rate 9600
Interface Underruns 0
Interface Overruns 0