Filter
Top Products
21-2 SmartSwitch 1800 4.0 User Guide, Rev 01
●
Rejected frames per sec (*10)
– is the number of frames rejected per second over
the five-second reporting interval, multiplied by 10.
●
Retransmitted frames per sec (*10)
– is the number of frames retransmitted per
second over the five-second reporting interval, multiplied by 10. If the value is
consistently greater than zero and there are no other problems, you should
increase the
T1
timer (
Retransmission Period
) in the Port record.
Configuring RLP Statistics Thresholds
For each RLP statistic, you can specify a threshold that, when crossed, causes an alarm
to be sent to the collecting node.
Press
[A]
at the Statistics Menu. When prompted for a
Statistic level
, press
[Enter]
,
accepting the default of
L
(for RLP). A menu similar to the following figure will be
displayed.
Figure 21-2 RLP Statistics Configuration Menu
[E],[A]
from Main Menu
Changing a threshold changes the database value. Press
[F7]
to write the
change to system memory.
A threshold is either a number or a percentage, depending on the statistic. The valid
range for any statistic is
0–65535
. (Default =
0.
) When the measured value for the sta-
tistic crosses the threshold (in either direction), an alarm is generated.
Node Name=node_xyz
RLP Statistics (Thresholds)
RLP: 0
Database System Memory
A Percentage of Buffers in Use 0 0
B Number of Queued Messages 0 0
C Received frames/Sec (*10) 0 0
D Transmitted frames/Sec (*10) 0 0
E Rejected frames/Sec (*10) 0 0
F Retransmitted Frames/Sec (*10)
Option: