Filter
Top Products
15-2 SmartSwitch 1800 4.0 User Guide, Rev 01
Configuring IPX Node Defaults
Press
[E]
at the Configure IP/LLC2/BRIDGE/IPX Default Parameters Menu (or
[A],
[A], [E], [E]
from the Main Menu) to configure default IPX node parameters.
Figure 15-1 IPX Node Defaults Menu
[A],[A],[E],[E]
from Main Menu
IPX Node Defaults Parameters
Internal Network
identifies the node to the IPX network. If fewer than 8 hex digits are entered, leading
zeros will be added.
Gap
is the minimum delay between consecutive RIP and SAP (Service Advertising Pro-
tocol) transmissions. This parameter provides compatibility with older Novell servers.
Router Name
is simply an identifier for the IPX network. It must be unique within the network.
Table 15-1 IPX Node Defaults Parameters
Parameter Valid Values Default Value
Internal Network
0–ffffffff
(8 hex digits)
00000000
Gap
(55 ms intervals)
0–100 1
Router Name
1–47 characters none
Node Name=nodexyz
Con figu re IPX N ode D efau lts
A Internal Network 0000001e
B Gap (55ms intervals) 1
C Router Name ipx_router_1
Option: