Filter
Top Products
Configuring X.25 8-31
Testing a Translation Template
Press
[C]
at the X.25 Address Translation Templates Menu (
[A], [C], [C], [C]
from the
Main Menu) to test a translation template you have created.
When prompted, enter:
●
Port
. (default is
0
.) Valid port numbers depend on the model of SmartSwitch
1800—see port locations on page 6-1.
●
Direction
:
I
(incoming) or
O
(outgoing). (Default is
I
.)
●
Called address
to be translated.
●
Calling address
to be translated.
●
Facility length + facility + user data
. (The user data includes four bytes for pro-
tocol ID, which must be entered as a hex string.) To specify only user data, at
the above prompt enter
00
for a facility length, nothing for a facility, then the
desired user data, including the 4-byte protocol ID.
After you enter this information, the SmartSwitch 1800 creates a test packet and sends
it through the translation process, and displays the results, as shown in the following
example.
Figure 8-11 Address Translation Test Screen
[A],[C],[C],[C]
from Main Menu
Node Name=nodexyz
Packet Translation Test
P or t:0 Di re c tion:Inc o mi ng
Original Packet: 10010B7712345673333333000100000035353535
Called Address: 1234567 Calling Address: 3333333
User Data Protocol ID: 01000000 User Data: 55555
Facilities:
Translation Template:
Template ID: 1234C*U*
Called Address: L8401X7 Callin g Address: P
User Data Protocol ID: P User Data: P
Facilities: P
Translated Packet: 10010B74840133333330000100000035353535
Called Address: 8401 Calling Address: 3333333
User Data Protocol ID: 01000000 User Data: 55555
Facilities:
Strike any key to continue