Filter
Top Products
Configuring Bridging 16-3
Configuring Default Node-Wide Bridging Parameters
If one or more Bridge ports (interfaces) will be established in the local node, certain
parameters must be configured to define bridge operation. Press
[B]
at the Configure
IP/LLC2/BRIDGE/IPX Default Parameters Menu (or
[A], [A], [E], [B]
from the Main
Menu). When prompted, enter:
●
Virtual LAN ID
– if also configuring LLC2 or Bridging in the node, enter a value
of
0–fff
(hex). Otherwise, press
[Enter]
(accepting the default of
000
).
LAN IDs can also be configured in LLC2 Interface/Bridge Port
records (later in this chapter). Each LAN ID must be unique
within the network on which this node will operate.
●
Any remaining requested information, referring to Table 16-1.
Figure 16-1 Bridge Node Defaults Configuration Screen
[A],[A],[E],[B]
from Main Menu
Node Name=node_xyz
Configure Bridge/LLC2 Node Defaults
A Virtual LAN ID 000
B Bridge Enabled N
C Bridge Hello Time 2
D Bridge Max Age 20
E Bridge Forward Delay 15
F Bridge Aging Timer (seconds) 300
G Bridge Priority 0
H Max Size Bridge Forwardin g Table 65535
I IP Br idg in g Ena b le d N
J IPX Bridging Enabled N
K SRB ID 0
L Default Ethernet Frame Type Type II
Option::